Solid tire Pressing Machine
1.Before you use the machine, please read the "instructions
"carefully!It will provide the relevant safety manual, installation,
adjustment, operation and maintenance of the necessary information.
2.If you are not in accordance with the specification requirements for
checking before you start or not in accordance with the instructions for
operation and maintenance may lead to machine failure or damage,
we will not undertake the responsibility !
3.YCTP-1800-25 can press below 23.5-25 tires . YCTP-1200-20 can press
below 1200-20 tires. YCTP-1600-15 can press below 28X9-15 tires .
YCTP-1200-12 is a type it can only press below 12In.
Work hydraulic : pressure 20MPa
Plunger diameter: φ 260m
Plunger stroke: 600mmPallet specifications :800mmX40mm
Plate spacing: 800mm
Motor power :5.5Kw
Net weight: 2000Kg
Overall dimensions :2100 x 800 x 2300 (length * width * height)
TP solid tire pressing machine is a special equipment for solid tire
loading and unloading, It can also apply FOR the tires below 15 In.
This machine is a frame structure.the hydraulic cylinder is located
above the piston movement from top to bottom, the department.
Platform, fixed on the piston rod and spherical pressure box, firm
structure, is made of high-quality materials carefully assembled, so
good performance. with the electric control box independent.
The hydraulic system consists of main hydraulic system and auxiliary
The hydraulic system is composed of the high-pressure pump, solenoid
valve, pressure relief valve, check valve, pressure indicator and oil
High pressure relief valve is the oil pressure setting of high pressure
pump, its maximum setting value is 20MPa.
Matters needing attention
1,The machine uses 46 original anti-wear hydraulic oil.you must filter
oil into the tank very carefully. and release the oil after using 3 - 4
The oil can be used after re-filtration and should be replaced per year.
Please clean the oil tank when you replace the oil.
2, Electrical equipment shall be reliably grounded.
3, Check the connection parts carefully before operation.4, Oil pressure should not be higher than 20MPa during working .
5, Cut off the power supply when shutting down for maintenance.
6, Because the pressure frame is heavy, a pressure cylinder is placed
under the pressure frame to Prevent oil leakage at piston rod caused
by side force.
Warning: During the assembly process of solid tire,please do not
use oil and grease substances on the tire and rim.which will cause
abnormal damage to the tire. we recommend diluted soapy water to
wipe the tire and the outer surface of the rim properly.
1,Motor rotates Anti-clockwise
2,Connection mode:Three phase four core wire,Three live wires are
connected to the upper air switch in the distribution cabinet;The zero
line is connected to the lowest zero line mark in the distribution